RobbSmarrt Rotary dimmer Z-Wave 2-wire
Installation via the Fibaro Home Center 2:
The first step is to connect the dimmer. Remove your old dimmer and unplug the wires. Obviously make sure you take the power off, a shock is so annoying. After this you connect the new dimmer according to the supplied scheme. You can connect it both 2 wire and 3 wire. The best result is the 3-wire variant.
Please wait a while to restore the power as it is easy to log in to the HC2 first. Once you have done this, go to your devices and click on "add new device". Then supply the dimmer with power. The LED on the front will flash red. You now have to make sure he can be found. You can do this by pressing a small screwdriver into the reset hole.
Dimmer & On/off, current consumption and total consumption
You have the following options at your disposal:
Table of content
- Zipato (ZipaTile/ZipaBox)
- Fibaro Home Center 2
- Vera (Plus/Edge)
- Conclusion Domoticz: This dimmer works fine. As usual with Domoticz, it is a bit of a search to determine which endpoints you have to switch on to make the right devices visible.
- Frequently Asked Questions
- Lamp test